Installing RoomDesign Pro Pendant

Before you begin 

Confirm the following before installation:

• RoomDesign Pro Pendant requires an external amplifier

• The ceiling structure can safely support the speaker and mount

• The correct operating mode is identified (8-ohm or 70/100V)

Installation steps 

1. Choose the mounting location

Pick a ceiling position that places the speaker above the listening area.

• Centre the speaker over where people sit or stand

• Avoid placing it too close to walls

• Make sure the ceiling point is strong and secure

Pendant mounting works best in tall or open spaces.

2. Mount the speaker

• Secure the suspension hardware to the ceiling

• Adjust the cable so the speaker hangs at the right height

• Check that the speaker hangs straight and feels stable

3. Set the operating mode

Set the mode before wiring, using the selector dial:

• 8-ohm for most standard amplifiers

• 70/100V for distributed audio systems

4. Connect the speaker

• Connect the speaker cable to the terminal connector on the rear of the speaker

• Route the cable neatly for a clean finish

• Connect the other end to an external analogue amplifier

Check that all connections are secure.

Installation complete 

RoomDesign Pro Pendant is now installed and ready to use. 

In summary 

• Suited to high or open ceilings

• External amplifier required

• Selectable 8-ohm or 70/100V operation

• Brings sound closer to listeners