Contents

1. Introduction

2. What's new in Room OS 2.4.1-38
   2.1 Camera support

3. How to check your firmware version

1. Introduction

This document describes the new features, improvements, bug fixes and known issues in the 2.4.1-38 firmware release for Pleneo RoomHub.

This release adds camera support to Room OS for Pleneo RoomVision and for third-party PTZ cameras using VISCA over IP.

2. What's new in Room OS 2.4.1-38

New features in this release

• Camera support: Pleneo RoomVision and third-party PTZ cameras (VISCA over IP)

  
  

2.1 Camera support

Room OS now supports Pleneo RoomVision cameras and third-party PTZ cameras using VISCA over IP.

Cameras are discovered on the network and added from the setup flow, in the same way as speakers and microphones.

For every supported camera, you can do the following from the Room OS web interface:

• Test the camera

• Control pan, tilt and zoom

• Save and recall presets

Pleneo RoomVision is configured directly in Room OS. No separate camera setup is required. Connect RoomVision to a PoE switch on the same network as RoomHub.

Third-party cameras must have VISCA over IP enabled and must be on the same network as RoomHub.

Tested cameras

• Pleneo RoomVision

• Canon N-Series

• Sony SRG Series

• AVer CAM570

• AVer TR315

Also compatible (VISCA over IP)

• Canon: CR-N100, CR-N300, CR-N350, CR-N400, CR-N500, CR-N700

• Sony: SRG-X400, SRG-X120, SRG-A40, SRG-A12, and earlier SRG models with current firmware

• AVer: PTZ310, PTZ330, PTZ211, PTZ231, TR320, TR530, TR530+

  
  

  
  

3. How to check your firmware version

RoomHub web interface: System → About. Pleneo Cloud: Devices view.